Livestock water tanks are covered under the "Livestock Water Tank Act of Colorado" sections 35-49-101 to 35-49-116, C.R.S. These structures include all reservoirs built after April 17, 1941, on watercourses which the state engineer has determined to be "normally dry" and having a capacity of not more than ten acre-feet and a vertical height not exceeding fifteen feet from the bottom of the channel to the bottom of the spillway. Again, as with erosion control dams, the height is measured from the lowest point of the upstream toe to the crest of the spillway. No livestock water tanks can be used for irrigation purposes.
Erosion control dams are governed under Colorado statute (see section 37-87-122, C.R.S. (1990). These types of structures may be constructed on water courses which have been determined by the state engineer to be normally dry (which for our purposes is dry more than 80% of the time). Structures of this type cannot exceed fifteen feet from the bottom of the channel to the bottom of the spillway and cannot exceed ten acre-feet at the emergency spillway level. The height of the dam is measured vertically from the lowest point of the upstream toe to the crest of the dam in contrast to those measured vertically from the centerline pursuant to section 37-87-105, C.R.S. (1990). Note: The structure can be larger than specified under section 37-87-122, however, it then will be evaluated and must be constructed pursuant to section 37-87-105.

Livestock water tanks are covered under the "Livestock Water Tank Act of Colorado" sections 35-49-101 to 35-49-116, C.R.S. These structures include all reservoirs built after April 17, 1941, on watercourses which the state engineer has determined to be "normally dry" and having a capacity of not more than ten acre-feet and a vertical height not exceeding fifteen feet from the bottom of the channel to the bottom of the spillway. Again, as with erosion control dams, the height is measured from the lowest point of the upstream toe to the crest of the spillway. No livestock water tanks can be used for irrigation purposes.
Erosion control dams are governed under Colorado statute (see section 37-87-122, C.R.S. (1990). These types of structures may be constructed on water courses which have been determined by the state engineer to be normally dry (which for our purposes is dry more than 80% of the time). Structures of this type cannot exceed fifteen feet from the bottom of the channel to the bottom of the spillway and cannot exceed ten acre-feet at the emergency spillway level. The height of the dam is measured vertically from the lowest point of the upstream toe to the crest of the dam in contrast to those measured vertically from the centerline pursuant to section 37-87-105, C.R.S. (1990). Note: The structure can be larger than specified under section 37-87-122, however, it then will be evaluated and must be constructed pursuant to section 37-87-105.

A Jurisdictional Dam is a dam creating a reservoir with a capacity of more than 100 acre-feet, or creates a reservoir with a surface area in excess of 20 acres at the high-water line, or exceeds 10 feet in height measured vertically from the elevation of the lowest point of the natural surface of the ground where that point occurs along the longitudinal centerline of the dam up to the crest of the emergency spillway of the dam. For reservoirs created by excavation, or where the invert of the outlet conduit is placed below the surface of the natural ground at its lowest point beneath the dam, the jurisdictional height shall be measured from the invert of the outlet at the longitudinal centerline of the embankment or from the bottom of the excavation at the longitudinal centerline of the dam, whichever is greatest. Jurisdictional height is defined in Rule 4.2.19. The State Engineer shall have final authority over determination of the jurisdictional height of the dam.

Livestock water tanks are covered under the "Livestock Water Tank Act of Colorado" sections 35-49-101 to 35-49-116, C.R.S. These structures include all reservoirs built after April 17, 1941, on watercourses which the state engineer has determined to be "normally dry" and having a capacity of not more than ten acre-feet and a vertical height not exceeding fifteen feet from the bottom of the channel to the bottom of the spillway. Again, as with erosion control dams, the height is measured from the lowest point of the upstream toe to the crest of the spillway. No livestock water tanks can be used for irrigation purposes.
Erosion control dams are governed under Colorado statute (see section 37-87-122, C.R.S. (1990). These types of structures may be constructed on water courses which have been determined by the state engineer to be normally dry (which for our purposes is dry more than 80% of the time). Structures of this type cannot exceed fifteen feet from the bottom of the channel to the bottom of the spillway and cannot exceed ten acre-feet at the emergency spillway level. The height of the dam is measured vertically from the lowest point of the upstream toe to the crest of the dam in contrast to those measured vertically from the centerline pursuant to section 37-87-105, C.R.S. (1990). Note: The structure can be larger than specified under section 37-87-122, however, it then will be evaluated and must be constructed pursuant to section 37-87-105.

Livestock water tanks are covered under the "Livestock Water Tank Act of Colorado" sections 35-49-101 to 35-49-116, C.R.S. These structures include all reservoirs built after April 17, 1941, on watercourses which the state engineer has determined to be "normally dry" and having a capacity of not more than ten acre-feet and a vertical height not exceeding fifteen feet from the bottom of the channel to the bottom of the spillway. Again, as with erosion control dams, the height is measured from the lowest point of the upstream toe to the crest of the spillway. No livestock water tanks can be used for irrigation purposes.
Erosion control dams are governed under Colorado statute (see section 37-87-122, C.R.S. (1990). These types of structures may be constructed on water courses which have been determined by the state engineer to be normally dry (which for our purposes is dry more than 80% of the time). Structures of this type cannot exceed fifteen feet from the bottom of the channel to the bottom of the spillway and cannot exceed ten acre-feet at the emergency spillway level. The height of the dam is measured vertically from the lowest point of the upstream toe to the crest of the dam in contrast to those measured vertically from the centerline pursuant to section 37-87-105, C.R.S. (1990). Note: The structure can be larger than specified under section 37-87-122, however, it then will be evaluated and must be constructed pursuant to section 37-87-105.

A Non-Jurisdictional Dam is a dam creating a reservoir with a capacity of 100 acre-feet or less and a surface area of 20 acres or less and with a height measured as defined in Rules 4.2.5.1 and 4.2.19 of 10 feet or less. Non-jurisdictional size dams are regulated and subject to the authority of the State Engineer consistent with sections 37- 87-102 and 37-87-105 C.R.S.

This list provides a summary of proposed projects to build new dams, enlarge existing dams, or perform maintenance/repair projects at existing dams. It contains projects that are currently under review and projects that have been approved or rejected within the last 45 days. The information is provided to educate the public about ongoing efforts to maintain and build dams in the state of Colorado and facilitate appeals pursuant to Rule 20 of 2-CCR-402-1.

A Non-Jurisdictional Dam is a dam creating a reservoir with a capacity of 100 acre-feet or less and a surface area of 20 acres or less and with a height measured as defined in Rules 4.2.5.1 and 4.2.19 of 10 feet or less. Non-jurisdictional size dams are regulated and subject to the authority of the State Engineer consistent with sections 37- 87-102 and 37-87-105 C.R.S.

Livestock water tanks are covered under the "Livestock Water Tank Act of Colorado" sections 35-49-101 to 35-49-116, C.R.S. These structures include all reservoirs built after April 17, 1941, on watercourses which the state engineer has determined to be "normally dry" and having a capacity of not more than ten acre-feet and a vertical height not exceeding fifteen feet from the bottom of the channel to the bottom of the spillway. Again, as with erosion control dams, the height is measured from the lowest point of the upstream toe to the crest of the spillway. No livestock water tanks can be used for irrigation purposes.
Erosion control dams are governed under Colorado statute (see section 37-87-122, C.R.S. (1990). These types of structures may be constructed on water courses which have been determined by the state engineer to be normally dry (which for our purposes is dry more than 80% of the time). Structures of this type cannot exceed fifteen feet from the bottom of the channel to the bottom of the spillway and cannot exceed ten acre-feet at the emergency spillway level. The height of the dam is measured vertically from the lowest point of the upstream toe to the crest of the dam in contrast to those measured vertically from the centerline pursuant to section 37-87-105, C.R.S. (1990). Note: The structure can be larger than specified under section 37-87-122, however, it then will be evaluated and must be constructed pursuant to section 37-87-105.

A Jurisdictional Dam is a dam creating a reservoir with a capacity of more than 100 acre-feet, or creates a reservoir with a surface area in excess of 20 acres at the high-water line, or exceeds 10 feet in height measured vertically from the elevation of the lowest point of the natural surface of the ground where that point occurs along the longitudinal centerline of the dam up to the crest of the emergency spillway of the dam. For reservoirs created by excavation, or where the invert of the outlet conduit is placed below the surface of the natural ground at its lowest point beneath the dam, the jurisdictional height shall be measured from the invert of the outlet at the longitudinal centerline of the embankment or from the bottom of the excavation at the longitudinal centerline of the dam, whichever is greatest. Jurisdictional height is defined in Rule 4.2.19. The State Engineer shall have final authority over determination of the jurisdictional height of the dam.